Products

Clutch alignment tool set - BMW air cooled twins '69 - '95

M22 x 1.5. Compatible with Round or Square case Bevel drive engines.

Clutch hub lock nut driver. O.D. 29.8mm. I.D. 20mm. 4 Pins, pin width 4.9mm.

Clutch hub lock nut driver. O.D. 29.7mm. I.D. 24.5mm. 4 Pins, Pin width 5mm.  

2-in-1 clutch hub lock nut driver. 4 Tang socket, 1/2" Drive. Tang sizes: O.D. 24.6 mm. I.D. 20.6 mm. 4 Pins, Pin width 5.2 mm. O.D. 29.6 mm. I....

2-in-1 clutch hub lock nut driver. 4 Tang socket, 1/2" drive. O.D. 31.9mm. I.D. 25.9mm. 4 Pins, Pin width 5.3mm. O.D. 35.9mm. I.D. 30.5mm. 4 Pin...

Special clutch locking tool

Co2 Bottle kit - 3 bottles plus connector

DS MK3610 - Coil spring compressor kit

Combination clutch drum holder plate for all Ducati Twins

Combination fork and cartridge tool set.  Up to Ø 65 mm

Remove and install the main drive gear or main bearing on the latest Harley Davidson 6-speed transmission without damaging the case.

Good for hydraulic clutch and bleeding brake systems. Available in 8 mm, 10 mm, 11 mm, 3/8"

Three leg puller for crankcase disassembly - small engine

Sets horizontal cylinder to TDC during timing belt replacement. *May require modification for some water-cooled models. Compatible with ALL Ducat...

Compatible with ALL Panigale 899, 959, 1199, 1299. Equivalent to Ducati P/N 88173.3824

Damper rod holders in small, medium and large  

- Long shaft designed for older Ohlins forks - Four square prongs - 1/2” SQ. drive end. - Ø36.1mm O.D. - Ø32.0mm I.D. - 4.8mm wide prongs x 4mm ...

- Two thread sizes M12 x 1 and M12 x 1.25 - For OHLINS FGRT. OHLINS’s tool: # 01765-05.

Double end lock nut socket driver. O.D. 39mm. I.D. 30.2mm. 4 Pins, Pin width 6.7mm. O.D. 26mm. I.D. 19.9mm. 4 Pins, Pin width 6.3mm.  

Double end lock nut socket driver - 1/2" drive Large end: O.D. Ø49.8mm, I.D. Ø36.5mm - 4 pins, 5.6mm wide Small end: O.D. Ø33.8mm, I.D. Ø25.5mm - ...

Double end lock nut socket driver. O.D. 34.2mm. I.D. 26.3mm. 4 Pins, pin width 5.6mm. O.D. 19.8mm. I.D. 14mm. 4 pins, pin width 3.7mm.

Drum and clutch basket holding tool - all Ducati 6 speed gear box '88-15

DS A114-32 – Cylinder head wrench – Removal and installation of the cylinder head. 15mm, 12pt. Compatible with 748, 749, 916, 996, 998, 999, Mons...