DS MK5730 - Hang up fuel tank. 2 lt DS MK5520 - Hang up fuel tank with fuel return line. 3.6 lt. A must for many fuel injected bikes
Pre-drilled holes for self-tapping screws provide additional grip for stubborn oil filters. 76mm I.D. (across points) x 8 flutes. 29mm wrench or ½"...
View full details
Oil filter cup wrench. 74 mm x 14 flutes notch type
Camshaft timing pulley holder and socket. Outer tool with handle for holding can pulley steady and inner socket to remove/tighten the pulley nut. ...
View full details
Engine mounting lock nut driver. O.D. 27mm. I.D. 20mm. 4 Pins, pin width 4.6mm.
Heavy duty chain breaker with folding handle
Fork seal driver. Expanding type. 26 - 45 mm
Fork oil level gauge. Check and adjust liquid levels in forks.
Fork cap driver designed for older FG series Ohlins forks. This tool will not fit newer FGRT forks and cartridge kits. 3/8" square / 24 mm hex dr...
View full details
Compatible with most Ducati models from 2001 – Current EXCEPT Panigale range. Equivalent to Ducati P/N 88713.2036, 88713.2101, 88713.3367
DS A 137-55 – Flywheel extractor – Uses ½” square drive or 24mm and 41mm wrench. Thread pitch M55 x 1.50. Compatible with 1199, 1299 Panigale. Equi...
View full details
Double end lock nut socket driver. O.D. 34.2mm. I.D. 26.3mm. 4 Pins, pin width 5.6mm. O.D. 19.8mm. I.D. 14mm. 4 pins, pin width 3.7mm.
Sets horizontal cylinder to TDC during timing belt replacement. *May require modification for some water-cooled models. Compatible with ALL Ducat...
View full details
- Long shaft designed for older Ohlins forks - Four square prongs - 1/2” SQ. drive end. - Ø36.1mm O.D. - Ø32.0mm I.D. - 4.8mm wide prongs x 4mm ...
View full details
Compatible with ALL Panigale 899, 959, 1199, 1299. Equivalent to Ducati P/N 88173.3824
Good for hydraulic clutch and bleeding brake systems. Available in 8 mm, 10 mm, 11 mm, 3/8"
Combination fork and cartridge tool set. Up to Ø 65 mm
2-in-1 clutch hub lock nut driver. 4 Tang socket, 1/2" Drive. Tang sizes: O.D. 24.6 mm. I.D. 20.6 mm. 4 Pins, Pin width 5.2 mm. O.D. 29.6 mm. I....
View full details
M22 x 1.5. Compatible with Round or Square case Bevel drive engines.
