Moto Tools

DS A 137-55 – Flywheel extractor – Uses ½” square drive or 24mm and 41mm wrench. Thread pitch M55 x 1.50. Compatible with 1199, 1299 Panigale. Equi...

Double end lock nut socket driver. O.D. 34.2mm. I.D. 26.3mm. 4 Pins, pin width 5.6mm. O.D. 19.8mm. I.D. 14mm. 4 pins, pin width 3.7mm.

Sets horizontal cylinder to TDC during timing belt replacement. *May require modification for some water-cooled models. Compatible with ALL Ducat...

- Long shaft designed for older Ohlins forks - Four square prongs - 1/2” SQ. drive end. - Ø36.1mm O.D. - Ø32.0mm I.D. - 4.8mm wide prongs x 4mm ...

Compatible with ALL Panigale 899, 959, 1199, 1299. Equivalent to Ducati P/N 88173.3824

Good for hydraulic clutch and bleeding brake systems. Available in 8 mm, 10 mm, 11 mm, 3/8"

Combination fork and cartridge tool set.  Up to Ø 65 mm

2-in-1 clutch hub lock nut driver. 4 Tang socket, 1/2" Drive. Tang sizes: O.D. 24.6 mm. I.D. 20.6 mm. 4 Pins, Pin width 5.2 mm. O.D. 29.6 mm. I....

M22 x 1.5. Compatible with Round or Square case Bevel drive engines.

Circlip pullers.  90 degrees, 50 mm deep

Chain clip link pliers.  Specifically designed for fitting / removing retaining clips.

Sets cam timing to factory specifications when replacing timing belts. Compatible with ST3. Equivalent to Ducati P/N 88713.2257

Sets cam timing to factory specifications when replacing timing belts. Compatible with 748, 916, 996, Monster 620, 750, 800, 900, S2R, S4, S4R, S...

Sets cam timing to factory specifications when replacing timing belts. Compatible with GT 1000, Hypermotard 796, 1100, MH900E, Monster 659, 696, ...

DS A114-24 Camshaft timing pulley socket (lock nut sizes 21 mm inside / 24 mm outside). Fits 748, 916, 996, ST4, GT 1000, Hypermotard 796, 1100, ...

Drift prevents seal damage during installation. Driver step sets seal depth. I.D. 19mm O.D. 24mm. Compatible with 749, 848, 998, 999, 1098, 1198,...

Holds camshaft sprocket when removing timing nuts. Verify camshaft sprocket diameter. I.D. 54.5mm O.D. 64mm - 18 tooth Multistrada 620 Monster 40...

Cam and crankshaft locking block for Harley Davidson DS A110-75 - FXD '06-> DS A110-76 - FXD '99-05

Non-power brake fluid receiver, capacity 1000cc.

Hang-up brake bleeding tank. The collection reservior eliminates annoying spills when changing the hydraulic fluid by using the brake or clutch le...

Offset handle provides additional clearance allowing drive belt adjustment without removing the rear wheel. Compatible with XDiavel. Equivalent...

Slide hammer bearing puller set with multiple attachment tips Kit includes 1/2" UNC slide hammer plus 9 bearing pullers for 10 bearing sizes: Ø8 ...

New from Dragonstone is this 12 Volt, multi-stage, automatic smart switching battery charger. With auto-switching between eight different charging ...

- CNC machine - Suits most Japanese models - 64 mm x 14 flats