Moto Tools

DS MK124-04 - spare shaft for wheel balancer diametre 12 mm DS EBSHAFT1/2 - spare shaft for wheel balancer diametre 1/2" EB SHAFT14 - spare shaft...

Rim protector set.  Nylon.  2 piece

DS MK5730 - Hang up fuel tank.  2 lt DS MK5520 - Hang up fuel tank with fuel return line. 3.6 lt.  A must for many fuel injected bikes  

Piston pin puller - diameter 13 mm - 22 mm

Pre-drilled holes for self-tapping screws provide additional grip for stubborn oil filters. 76mm I.D. (across points) x 8 flutes. 29mm wrench or ½"...

Oil filter cup wrench.  74 mm x 14 flutes notch type

Mini chain press.

Camshaft timing pulley holder and socket. Outer tool with handle for holding can pulley steady and inner socket to remove/tighten the pulley nut. ...

Engine mounting lock nut driver.  O.D. 27mm. I.D. 20mm. 4 Pins, pin width 4.6mm.

Adjustable hook wrench 25-70 mm

Heavy duty chain breaker with folding handle

The Dragon Stone Fork Oil Level Gauge makes setting the correct fork oil level quick, easy and accurate. Simply fill the fork with slightly more oi...

Fork cap driver designed for older FG series Ohlins forks.  This tool will not fit newer FGRT forks and cartridge kits. 3/8" square / 24 mm hex dr...

Foldable silicon funnel

Flywheel holder

Compatible with most Ducati models from 2001 – Current EXCEPT Panigale range. Equivalent to Ducati P/N 88713.2036, 88713.2101, 88713.3367

DS A 137-55 – Flywheel extractor – Uses ½” square drive or 24mm and 41mm wrench. Thread pitch M55 x 1.50. Compatible with 1199, 1299 Panigale. Equi...

Double end lock nut socket driver. O.D. 34.2mm. I.D. 26.3mm. 4 Pins, pin width 5.6mm. O.D. 19.8mm. I.D. 14mm. 4 pins, pin width 3.7mm.

Sets horizontal cylinder to TDC during timing belt replacement. *May require modification for some water-cooled models. Compatible with ALL Ducat...

- Long shaft designed for older Ohlins forks - Four square prongs - 1/2” SQ. drive end. - Ø36.1mm O.D. - Ø32.0mm I.D. - 4.8mm wide prongs x 4mm ...

Good for hydraulic clutch and bleeding brake systems. Available in 8 mm, 10 mm, 11 mm, 3/8"

Combination fork and cartridge tool set.  Up to Ø 65 mm

2-in-1 clutch hub lock nut driver. 4 Tang socket, 1/2" Drive. Tang sizes: O.D. 24.6 mm. I.D. 20.6 mm. 4 Pins, Pin width 5.2 mm. O.D. 29.6 mm. I....

M22 x 1.5. Compatible with Round or Square case Bevel drive engines.