Dragon Stone portable fuel tanks
DS MK5730 - Hang up fuel tank. 2 lt DS MK5520 - Hang up fuel tank with fuel return line. 3.6 lt. A must for many fuel injected bikes
DS MK5730 - Hang up fuel tank. 2 lt DS MK5520 - Hang up fuel tank with fuel return line. 3.6 lt. A must for many fuel injected bikes
Pre-drilled holes for self-tapping screws provide additional grip for stubborn oil filters. 76mm I.D. (across points) x 8 flutes. 29mm wrench or ½"...
View full detailsOil filter cup wrench. 74 mm x 14 flutes notch type
Layshaft timing pulley holder and socket. Fits ALL Ducati models with cam belt. Can also be used on 748, 916, 996, ST4, S4, S4R CAMSHAFT pulley n...
View full detailsEngine mounting lock nut driver. O.D. 27mm. I.D. 20mm. 4 Pins, pin width 4.6mm.
Heavy duty chain breaker with folding handle
Fuel mixture screw kit extension for Keihin carbs. Suits YZ/WR 250/450, CRF 250/450, KX 250, RMZ 250, KTM 450/525. Easy access to clean up low en...
View full detailsFork top nut spanner - 49 and 50 mm
Fork seal driver. Expanding type. 26 - 45 mm
Fork oil level guage. Check and adjust liquid levels in forks.
Fork cap driver designed for older FG series Ohlins forks. This tool will not fit newer FGRT forks and cartridge kits. 3/8" square / 24 mm hex dr...
View full detailsCompatible with most Ducati models from 2001 – Current EXCEPT Panigale range. Equivalent to Ducati P/N 88713.2036, 88713.2101, 88713.3367
DS A 137-55 – Flywheel extractor – Uses ½” square drive or 24mm and 41mm wrench. Thread pitch M55 x 1.50. Compatible with 1199, 1299 Panigale. Equi...
View full detailsDouble end lock nut socket driver. O.D. 34.2mm. I.D. 26.3mm. 4 Pins, pin width 5.6mm. O.D. 19.8mm. I.D. 14mm. 4 pins, pin width 3.7mm.
- Two thread sizes M12 x 1 and M12 x 1.25 - For OHLINS FGRT. OHLINS’s tool: # 01765-05.
Sets horizontal cylinder to TDC during timing belt replacement. *May require modification for some water-cooled models. Compatible with ALL Ducat...
View full details- Long shaft designed for older Ohlins forks - Four square prongs - 1/2” SQ. drive end. - Ø36.1mm O.D. - Ø32.0mm I.D. - 4.8mm wide prongs x 4mm ...
View full details