Dragon Stone fork top nut spanner 49 and 50 mm
Fork top nut spanner - 49 and 50 mm
Fork top nut spanner - 49 and 50 mm
Fork seal driver. Expanding type. 26 - 45 mm
Fork oil level guage. Check and adjust liquid levels in forks.
Fork cap driver designed for older FG series Ohlins forks. This tool will not fit newer FGRT forks and cartridge kits. 3/8" square / 24 mm hex dr...
View full detailsCompatible with most Ducati models from 2001 – Current EXCEPT Panigale range. Equivalent to Ducati P/N 88713.2036, 88713.2101, 88713.3367
DS A 137-55 – Flywheel extractor – Uses ½” square drive or 24mm and 41mm wrench. Thread pitch M55 x 1.50. Compatible with 1199, 1299 Panigale. Equi...
View full detailsDouble end lock nut socket driver. O.D. 34.2mm. I.D. 26.3mm. 4 Pins, pin width 5.6mm. O.D. 19.8mm. I.D. 14mm. 4 pins, pin width 3.7mm.
- Two thread sizes M12 x 1 and M12 x 1.25 - For OHLINS FGRT. OHLINS’s tool: # 01765-05.
Sets horizontal cylinder to TDC during timing belt replacement. *May require modification for some water-cooled models. Compatible with ALL Ducat...
View full details- Long shaft designed for older Ohlins forks - Four square prongs - 1/2” SQ. drive end. - Ø36.1mm O.D. - Ø32.0mm I.D. - 4.8mm wide prongs x 4mm ...
View full detailsCompatible with ALL Panigale 899, 959, 1199, 1299. Equivalent to Ducati P/N 88173.3824
Good for hydraulic clutch and bleeding brake systems. Available in 8 mm, 10 mm, 11 mm, 3/8"
Combination fork and cartridge tool set. Up to Ø 65 mm
2-in-1 clutch hub lock nut driver. 4 Tang socket, 1/2" Drive. Tang sizes: O.D. 24.6 mm. I.D. 20.6 mm. 4 Pins, Pin width 5.2 mm. O.D. 29.6 mm. I....
View full detailsM22 x 1.5. Compatible with Round or Square case Bevel drive engines.
Chain clip link pliers. Specifically designed for fitting / removing retaining clips.
Sets cam timing to factory specifications when replacing timing belts. Compatible with ST3. Equivalent to Ducati P/N 88713.2257
This handy tool features a 280 mm long driver with an 8 mm hex socket and flat blade screwdriver. It allows the lock nut to be undone and re-tighte...
View full detailsSets cam timing to factory specifications when replacing timing belts. Compatible with 748, 916, 996, Monster 620, 750, 800, 900, S2R, S4, S4R, S...
View full detailsSets cam timing to factory specifications when replacing timing belts. Compatible with GT 1000, Hypermotard 796, 1100, MH900E, Monster 659, 696, ...
View full detailsDS A114-24 Camshaft timing pulley socket (lock nut sizes 21 mm inside / 24 mm outside). Fits 748, 916, 996, ST4, GT 1000, Hypermotard 796, 1100, ...
View full details